Group 3 Electrical System - Hyundai r35z-7 Workshop Manual

GROUP 3 ELECTRICAL SYSTEM

1. WHEN STARTING SWITCH IS TURNED ON, MONITOR PANEL DISPLAY DOES NOT
APPEAR
Before disconnecting the connector, always turn the starting switch OFF.
Before carrying out below procedure, check all the related connectors are properly inserted and
short of fuse No. 2.
After checking, insert the disconnected connectors again immediately unless otherwise specified.
Check voltage
between CN-56
(2) and chassis
Starting switch : ON
Voltage : 10~12.5V
Check voltage
YES 10 ~ 12.5V
NO
0V
CLUSTER
POWER IG(12V)
YES
NO
1
2
3
17
CN-56
5-24
Cause Remedy
Defective cluster Replace
Disconnection in Repair or
wiring harness or replace
poor contact (After clean)
between CN-56
(1) and fuse No.2.
FUSE
NO.2
R35Z75TS10