Hyundai r35z-7 Workshop Manual page 336

(27)
Remove floating seal (1-2) and angular
bearing (1-3).
(28) Remove other floating seal (1-2) by use of
two drivers.
Tools required :
Screw driver (No. 13)
Be careful not to damage the sliding
surface of floating seal (1-2).
(29) Apply pre-bar to the hold of spline, and
remove shaft (2) striking it by hammer.
Tools required :
Screw driver (No. 12)
Round bar dia. 10 150mm(S-7)
(30) Remove oil seal (4).
Tools required :
Screw driver (No. 13)
Hammer (No. 14)
2
4
7-76
1-2
1-3
R35Z77TM28
R35Z77TM29
R35Z77TM30
R35Z77TM31