Hyundai r35z-7 Workshop Manual page 317

Press-fit the shaft (2-3) and the ball
bearing (2-2) in the case (2-1).
Apply grease to the back side of the
thrust plate (2-4) and assemble it.
The thrust plate must be assembled in
the correct direction.
Assemble the cylinder block (2-5) and
other associated parts.
During assembly, be sure that the pin (2-
10) will not come out.
The disk(2-14) is assembled only for the
parking brake spec only.
Apply grease to the O-ring (2-16) and the
O-ring (2-17) and assemble them on the
brake piston (2-15).
While paying attention to the location of
the hole of the pin (2-25), assemble the
brake piston (2-15) in the case (2-1).
2-15
2-17
2-16
7-57
2-3
2-2
R35Z77SM14
2-4
R35Z77SM13
2-5
R35Z77SM09
R35Z77SM37