Hyundai r35z-7 Workshop Manual page 304

4 4 ) ASSEMBLY
General precaution
(1)
In this assembly section, explanation only
is shown.
For further understanding, please refer to
the figures shown in the previous
structure & disassembly section.
Pay close attention to keeping all seals
free from handling damage and inspect
carefully for damage before using them.
Apply clean grease or hydraulic oil to the
seal so as to ensure it is fully lubricated
before assembly.
Do not stretch seals so much as to
deform them permanently.
In fitting O-rings, pay close attention not
to roll them into their final position in
addition, a twisted O-ring cannot easily
untwist itself naturally and could thereby
cause inadequate sealing and thereby
both internal and external oil leakage.
Tighten fitting bolts for all sections with a
torque wrench adjusted to the respective
tightening torque.
Do not reuse removed O-rings and seals.
( ( 2) Load check valve
Assemble the load check valve(3) and
O-ring(5), spring(4).
Put O-rings on to plug(6).
Tighten plug to the specified torque.
Hexagon wrench : 8mm
Tightening torque : 3.7kgf m
(26.7lbf ft)
7-44
5
4
3
R35Z77MCV12
6
R35Z77MCV11