Hyundai r35z-7 Workshop Manual page 334

(19) Remove thrust plate (1-13) and screw (1-
14).
Tools required :
Torque wrench (No. 1)
Hexagonal bit for torque wrench (No. 6)
It is easy to remove the screw after
heated fully by heater because screw (1-
14) is applied loctite.
(20)
Remove planetary gear B (1-9), needle
bearing (1-10), inner race (1-11) and
thrust washer (1-12).
Be careful not to damage the tooth
surface of gear and the rolling section of
the collar.
(21) Remove plug (1-8).
Tools required :
Torque wrench (No. 1)
Hexagonal bit for torque wrench (No. 7)
Take out steel balls (1-7) from the
(22)
threaded hole of plug (1-8). After
degreasing (thinner, white gasoline. etc),
take out them by blowing air. Put piano
wire through the threaded hole to be sure
that all steel balls (1-7) are taken out.
Tools required :
Hammer (No. 14), piano wire (S-4)
When it is difficult to remove, take out
steel balls (1-7) striking around housing
(1-6) by hammer.
1-6
1-7
1-8
7-74
1-15 1-17
1-19
1-20
1-18
1-22
1-23
1-12
1-10
1-11
R35Z77TM19
1-9
R35Z77TM21
R35Z77TM22
R35Z77TM23