Hyundai r35z-7 Workshop Manual page 341

(9)
Wrap plug (1-8) with seal tape, and tighten
it.
Tools required :
Torque wrench (No. 1)
Hexagonal bit for torque wrench (No. 7)
Tightening torque 0.8 0.1 kgf m
Tighten plug (1-8) until the head of plug is
obscured against the surface of sprocket
guide.
(10)
Install planetary gear B (1-9), needle
bearing (1-10), inner race (1-11) and
thrust washer (1-12).
(11) Put thrust plate (1-13) on the trunnion
section of flange holder, apply loctite #262
to screw (1-14) and tighten it.
Before applying the loctite, degrease the
parts completely and us hardening
accelerator.
Tools required :
Torque wrench (No. 1)
Hexagonal bit for torque wrench (No. 6)
Tightening torque 1.3 0.06 kgf m
(12)
Install sun gear assy (1-15) with snap ring
(1-16), holder (1-17) with inner race (1-
20), planetary gear A (1-18), needle
bearing (1-19) and drive gear (1-22).
(5.8 0.7 lbf ft)
(9.4 0.4 lbf ft)
7-81
R35Z77TM58
1-12
1-10
1-11
1-9
R35Z77TM59
1-14
R35Z77TM20
1-15 1-17
1-19
1-20
1-18
1-22
1-23
R35Z77TM19