Hyundai r35z-7 Workshop Manual page 342

(13) Install thrust plate (1-23).
(14)
Apply grease to O-ring (1-25), fit the O-
ring on cover (1-24), and install cover (1-
24) to housing (1-6) matching the
threaded hole of socket plug (1-8) of
housing (1-6) with the U-groove (for piano
wire).
Tools required :
Plastic hammer (No. 14)
Eye bolt (S-2)
(15) Bend 6 [mm] of the top end of wire (1-26)
at right angle, insert it into the threaded
hole of the housing, and wind the piano
wire turning the cover. Wrap socket plug
(1-8) with seal tape before tightening.
Tools required :
Eye bolt (S-2)
Round bar dia. 20 1000 [mm] (S-3)
Torque wrench (No. 1)
Hexagonal bit for torque wrench (No. 7)
Tightening torque 0.8 0.1 kgf m
(16)
Apply grease to oil seal (4) and press fit it
in flange holder.
Tools required :
Oil seal press fitting jig (S-12)
(5.8 0.7 lbf ft)
7-82
R35Z77TM60
R35Z77TM61
R35Z77TM17
4
R35Z77TM62