Crop Dividers; Removing Crop Dividers From Header With Latch Option - MacDon D65 Operator's Manual

4.7.11 Crop Dividers

Crop dividers are used to help divide the crop when harvesting. They are removable to allow installation of vertical
knives and to decrease transport width.

Removing Crop Dividers from Header with Latch Option

To remove crop dividers from a header with the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. See your windrower
operator's manual for instructions for use and storage of header safety props.
1. Raise header, stop engine, remove key, and engage
header safety props. For instructions, refer to your
windrower operator's manual.
2. Open/remove header endshields. See Section
Endshields, page 37.
3. Lift safety lever (A).
4. Hold onto divider (B), push lever (C) to open latch and
lower divider.
5. Lift divider off endsheet and store as follows:
a. Locate pin (A) on divider in hole in endsheet at
location shown.
b. Lift divider and locate lugs (B) on divider into
bracket on endsheet. Ensure lugs engage bracket.
6. Close/replace header endshields. See Section
Endshields, page 37.
169594
OPERATION
4.2.3
Figure 4.49
4.2.3
Figure 4.50
69
Rev. C