Replacing Stub Guards On A Double-Knife Header - MacDon D65 Operator's Manual

IMPORTANT
The first four outboard guards on drive side(s) of
the header do NOT have a ledger plate. Ensure
that the proper replacement is installed.
4. Check and adjust clearance between top guide and
knife. Refer to Knife Hold-Downs, page

Replacing Stub Guards on a Double-Knife Header

Refer to Replacing Stub Guards on a Single-Knife Header,
page 145 for typical guard replacement.
The guard at the center of the Double Knife header,
where the two knives overlap, requires a slightly different
replacement procedure.
To replace the center guard or center top guide, follow
these steps:
169594
MAINTENANCE AND SERVICING
147.
146
Figure 6.41: Check clearance
A - Normal guard B - Drive side guard
Rev. C