Installing Side Draper; Adjusting Side Draper Tension - MacDon D65 Operator's Manual

6.7.2 Installing Side Draper

To install a header draper, follow these steps:
WARNING
To avoid bodily injury from fall of raised reel,
always engage reel safety props before going
under raised reel for any reason.
1. Insert draper into deck at outboard end, under the
rollers. Pull draper into deck while feeding it at the end.
2. Feed in the draper until it can be wrapped around the
drive roller.
3. Similarly, insert the other end into the deck over the
rollers. Pull draper fully into the deck.
4. Attach ends of draper with tube connectors (B).
5. Install screws (A) with heads facing the center opening.
6. Adjust tension. Refer to Section
Draper Tension, page

6.7.3 Adjusting Side Draper Tension

To adjust the header draper tension, follow these steps:
1. Check that draper guide (rubber track on underside of
draper) is properly engaged in groove of drive roller and
that idler roller is between the guides.
169594
MAINTENANCE AND SERVICING
6.7.3 Adjusting Side
182.
Figure 6.124
Figure 6.125
182
Rev. C