Closing Endshields - MacDon D65 Operator's Manual

2. Use tool (B) to unlock latch (A) at lower rear corner
of endshield.
3. Lift shield at aft end to clear pin at top rear of endshield.
4. Swing shield out and away from header while
maintaining forward pressure to prevent shield from
slipping out of tab (C) at front of endsheet.
IMPORTANT
Do NOT force shield once it has reached its end
of travel, as damage to the shield structure can
occur. Shield is designed to open sufficiently for
normal access to the drive system and manual
case as shown.
NOTE: If more access is required to the front
of the drives area, carefully disengage
front of shield from tab at the front of
the endsheet and then swing front of the
shield away from the header.
NOTE: If complete access to the endsheet area
is required, the shield can be removed.
See Removing Endshields, page

Closing Endshields

To close an endshield, follow these steps.
1. Maintain forward pressure and swing rear of shield
towards header.
2. Lift shield and engage pin (C) on top of frame endsheet.
169594
OPERATION
Figure 4.8
39.
Figure 4.9
Figure 4.10
38
Rev. C