Setting The Default Transmission Mode; Turning Remote Diagnosis On/Off - Kyocera KM-C830 Operation Manual

Section 6 Various Settings and Registration in this Fax
Setting the Default Transmission
Mode
You can select which transmission mode, Memory Transmission or
Direct Feed Transmission, will be the default setting in this fax.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode
settings.
Set Document
1. Raise the cover plate and press the Configure key.
-
Set Fax:
End
Line Type
TTI
2. Use the cursor up or the cursor down key to select "TX
Mode/Default".
Set Fax:
Set Volume
Scan from ADF :Std size
TX/Default
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select the desired
transmission mode.
* The asterisk ( ) in the message display indicates the current
*
setting.
TX Mode/Default:
*Default Feed Transmission
Memory Transmission
5. Press the Enter key. The setting for the transmission mode is
complete.
Set Fax:
Set Volume
Scan from ADF :Std size
TX/Default
* If you are finished making settings, press the Reset key. The
operation panel will return to the initial mode settings.
6-10
JUL-08-2001 12:00
:Tone Dial
:Outside P.
P P
:Memory
P P
:Direct

Turning Remote Diagnosis ON/OFF

Especially if trouble occurs in this fax in which it is necessary to call
for service, it is possible for our service center computer to access
the fax directly over the telephone line and check its status and other
information about the trouble.
* To use Remote Diagnosis, it is necessary to enter into a contract
with an authorized service center in advance and also to register a
predetermined Remote Test ID in advance.
(Refer to "Registering the Remote test ID".)
For further information, contact your service representative, an
authorized service center or the place of purchase.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
1. Raise the cover plate and press the Configure key.
Set Fax:
End
Line Type
TTI
2. Use the cursor up or the cursor down key to select "Remote Diag."
["Remote diagn."].
Set Fax:
2 in 1 RX
Management
Remote Diag.
3. Press the Enter key.
Remote Diag.:
*On
Off
4. Use the cursor up or the cursor down key to select whether to turn
Remote Diagnosis ON or OFF.
* The asterisk ( ) in the message display indicates the current
*
setting.
5. Press the Enter key. The setting for Remote Diagnosis is complete.
Set Fax:
2 in 1 RX
Management
Remote Diag.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
JUL-08-2001 12:00
:Tone Dial
:Outside P.
:Off
:Off
:On
:Off
:Off
:Off