Kyocera KM-C830 Operation Manual page 12

Section 1 Basic Use of this Fax
& Memory Tx. indicator...When this indicator is lit, the fax is in the
Memory Transmission mode. When the indicator is out, the fax is
in the Direct Feed Transmission mode.
* On-Hook indicator...This indicator will light when the On-Hook
key has been pressed and the telephone receiver is still "on the
hook" (dialing will be possible without picking up the receiver).
( TAD indicator...When this indicator is lit, the fax is in the TAD
Reception mode.
) Auto Rx. indicator
When this indicator is lit, the fax is in the Auto Fax Reception
mode.
⁄ Memory Tx. key...Press this key when you want to switch
between the Memory Transmission and Direct Feed
Transmission modes.
¤ On-Hook key...Press this key when you want to dial without
picking up the telephone receiver. Press the key again to cancel
that state.
‹ Pause/Redial key...Press this key when the fax is in the Direct
Feed Transmission mode and you want to have the fax
automatically redial the most recently dialed number. Press this
key also while entering a fax number when you want to insert a
pause of a few seconds at that point in dialing. A pause is
indicated by a dash ( - ) in the message display.
› Abbr./Directory key...Press this key when you want to dial with
abbreviated numbers or you want to access the directory.
1-4
(Right portion, with cover plate lowered)
& ‚ ·— ¤ ⁄
* ()‡ fl ‹ ›
fi
fi One-touch keys (No. 1 - No. 32)...32 one-touch keys are
available for use with this fax. Lower the cover plate when you
want to access one-touch keys No. 1 - No. 20 and raise the cover
plate in order to access one-touch keys No. 21 - No. 32. You can
designate each of the keys to function as either a one-touch key,
a program key, a group dial or a chain dial key. Use these keys
as well during the registration of destination names, etc.
fl Resolution select key...Press this key when you want to select
the degree of resolution at which the documents will be
transmitted.
‡ Resolution indicators...Select among the 5 available resolution
settings: Normal, Fine, Super Fine, Ultra Fine and Half Tone.
Ordinarily, all of the resolution indicators will be out; and the
Normal resolution is thus selected. If you want to use any
resolution other than Normal, press the resolution select key until
the resolution indicator that corresponds to the desired resolution
is lit.
— Communication Error indicator...When this indicator is lit, a
communications error has occurred.
· Communicating indicator...When this indicator is lit, a fax
communication is currently in progress. When a separately
purchased telephone is connected to this fax machine, this
indicator will flash while it's being used.
‚ Document in Memory indicator...When this indicator is lit, there
are documents in memory that are waiting to be printed or
communications that are waiting for their appointed start time.
When this indicator is flashing, documents are currently being
scanned or received into memory.