Duplex Transmission - Kyocera KM-C830 Operation Manual

Section 2 Various Functions of this Fax

Duplex Transmission

Duplex Transmission enables the transmission of both the front
and back sides of duplex (2-sided) documents when the optional
RADF document feeder is installed. Duplex transmission is
always accomplished by setting the documents you want to
transmit in the RADF and scanning them into memory in the
Memory Transmission mode. It is also possible to use Duplex
Transmission capabilities in combination with each of the other
various types of fax communication available in this fax. The
following method explains the procedure for sending duplex
documents to a single destination.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
1. Set the 2-sided documents in the RADF.
Enter Destination
2. Raise the cover plate and press the Duplex Tx. key.
* You can cancel a Duplex Transmission by simply pressing the
Duplex Tx. key again.
-
v :
Enter Destination
3. Enter the destination fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys or the directory. Chain dial keys can be
used as well.
v :35642
Enter Destination
2-2
JUL-08-2001 12:00
JUL-08-2001 12:00
1
Document:8 / x11
2
D
1
Document:8 / x11
2
D
1
Document:8 / x11
2
* To enable Duplex Transmission, you must select "Standard
size original" when setting the document size for scanning from
the Document Feeder. Duplex Transmission will not be
available if the document size is set to "Long original".
(Refer to "Setting the Document Size for Scanning from the
Document Feeder", page 6-6.)
* If you press the Duplex Tx. key during any operation,
Dial Confirmation for one-touch keys will not be available.
It will also be necessary to press the Start key in order to
initiate dialing for abbreviated numbers and one-touch keys.
* In order to schedule a start time for the transmission, press the
Delayed Tx. key at any point in the procedure PRIOR to
entering the destination fax number.
4. Press the Enter key.
Cover page:
Yes
No
5. Use the cursor up or the cursor down key to select whether or not
you want to include a cover page with the transmission.
> If you want to include a 1-sided page as a cover sheet, select
"Yes". In this case, the fax will first transmit only the front side
of the first page of the documents PRIOR to transmitting the
2-sided documents.
> If you only want to transmit the 2-sided documents, select "No".
6. Press the Enter key.
Rotate back side image:
On
Off
7. Use the cursor up or the cursor down key to select whether or not
you want the data for the rear side of the documents to be inverted
to match the orientation of the front side during transmission.
> If you set the documents as shown in the illustration immediately
below, select "On". The fax will then invert the image of the rear
side of each document in memory 180°.
<Scanning>
(Direction of document feed)
> If you set the documents as shown in the illustration below,
select "Off".
<Scanning>
(Direction of document feed)
8. Press the Enter key. The documents will be scanned into memory
and the transmission operation will begin automatically.
<Printout at the
destination fax>
<Printout at the
destination fax>