Kyocera KM-C830 Operation Manual page 103

2. Use the cursor up or the cursor down key to select "Program
Program key".
Program:
Program Abbreviated Dial
Program 1-Touch Key
Program Program Key
3. Press the Enter key.
ProgramKey:
Press 1-Touch Key
4. Press an unregistered one-touch key.
* The program key will be registered under that one-touch key.
ProgramKey:05:Select Mode
Send
Broadcast
RX Polling
5. Proceed to the procedure for the desired communication.
A. Standard Transmission ......................................This page
B. Broadcast Transmission...........................................P4-30
C. Polling Reception .....................................................P4-32
Section 4 Other Features of this Fax
A. Standard Transmission
6. Make sure that "Send" is selected in the message display.
* If it is NOT selected, use the cursor up or the cursor down key to
select it.
ProgramKey:05:Select Mode
Send
Broadcast
RX Polling
7. Press the Enter key.
Delayed Comm.:
On
Off
8. Use the cursor up or the cursor down key to select whether or not
you want to designate a time for the transmission to begin.
> If you want to designate a time for the transmission to begin,
select "On" and proceed to step 9.
> If you want to have the transmission begin immediately after the
program key is pressed, select "Off" and proceed to step 11.
9. Press the Enter key.
10. Use the keypad to enter the desired time for the transmission to
begin.
* If you want to reset the displayed time to "00:00", simply press
the Stop/Clear key.
TX Time:17:00
Enter TX Time
11. Press the Enter key.
v :
Enter Fax No.
12. Use the keypad to enter a destination fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys or the directory. Chain dial keys can
be used as well.
If you enter the fax number using an abbreviated number or
one-touch key that is already designated for F-Code Based
Communication, you can skip steps 13 through 16.
13. If you want to designate this communication as an F-Code Based
Transmission, press the Sub Address key.
> If you pressed the Sub Address key, proceed to step 14 on
page 4-30.
> If you DID NOT press the Sub Address key, proceed to step 17
on page 4-30.
(Continued from step 5)
4-29