Interrupt Transmission - Kyocera KM-C830 Operation Manual

Section 2 Various Functions of this Fax

Interrupt Transmission

Interrupt Transmission lets you send your documents before
others, eliminating the need to wait until all communications are
complete whenever the fax is currently scheduled for multiple
communications (Broadcast Transmission or Polling Reception,
etc.), or there are other communications already scheduled in
memory ahead of yours.
* The fax is currently occupied with a communication in the
background.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
1. Press the Memory Tx. key.
* Make sure the Memory Tx. indicator is out (the fax is in the
Direct Feed Transmission mode).
2-6
JUL-08-2001 12:00
* Interrupt Transmission may only be accomplished to a single
destination.
* You can schedule up to 50 Interrupt Transmissions (including
communications that use the timer and Interrupt Transmissions)
at one time.
* Depending on the timing of when you perform the Interrupt
Transmission procedure, there are occasions where your
documents may not be send immediately after the current
communication.
* If you want to cancel an Interrupt Transmission, simply remove
the documents from the DF or the platen.
* If you press the Stop/Clear key while an Interrupt Transmission
is waiting to start, perform the same procedure as in "
press the Stop/Clear key during a Standby Transmission in the
Direct Feed Transmission mode...", page 2-3.
2. Set the documents you want to transmit in the DF or on the platen.
* When the documents are set on the platen, it is necessary, after
each page is scanned, to select whether or not you want to
transmit more pages. (Refer to page 1-23.)
Enter Destination
3. Enter the destination fax number.
v :3323
Press START key.
4. Press the Start key. The documents will remain in the DF or on the
platen, without being scanned, waiting for the transmitting
operation to begin.
Once the operation currently in progress is completed,
the transmission operation for your documents will begin
automatically.
If you
JUL-08-2001 12:00
1
Document:8 / x11
2
1
Document:8 / x11
2