Turning Password Check Reception On/Off - Kyocera KM-C830 Operation Manual

6. Press the Enter key.
The setting for Password Check Transmission is complete.
Password Check Comm.:
End
Send
Receive
7. Use the cursor up or the cursor down key to select "End".
Password Check Comm.:
End
Send
Receive
8. Press the Enter key.
The message display will return to the "Set Fax" menu.
Set Fax:
TTI
Print Report
Password Check Comm.
9. Use the cursor up or the cursor down key to select "End".
Set Fax:
End
Line Type
TTI
10. Press the Enter key.
The operation panel will return to the initial mode settings.
:On
:Off
:On
:Off
:Outside P.
P P
P P
:Tone Dial
:Outside P.
Section 4 Other Features of this Fax
(6) Turning Password Check Reception
ON/OFF
Turn Password Check Reception ON when you want to limit from
whom fax communication can be accomplished by turning one or
both of the Password Check Communication modes ON.
(Refer to page 4-35.)
* If there are no Permit Telephone Numbers or Permit IDs registered
in this fax, Password Check Reception will not be possible even if it
is turned ON here.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
1. Perform steps 1 - 3 of "(5) Turning Password Check Transmission
ON/OFF", page 4-38.
Password Check Comm.:
End
Send
Receive
2. Use the cursor up or the cursor down key to select "Receive".
Password Check Comm.:
End
Send
Receive
3. Press the Enter key.
Password RX:
On
*Off
4. Use the cursor up or the cursor down key to select whether to turn
Password Check Reception ON or OFF.
* The asterisk ( ) in the message display indicates the current
*
setting.
5. Press the Enter key. The setting for Password Check Reception is
complete.
Password Check Comm.:
End
Send
Receive
6. Use the cursor up or the cursor down key to select "End" and then
press the Enter key.
The message display will return to the "Set Fax" menu.
Set Fax:
TTI
Print Report
Password Check Comm.
7. Use the cursor up or the cursor down key to select "End" and then
press the Enter key.
The operation panel will return to the initial mode settings.
JUL-08-2001 12:00
:Off
:Off
:Off
:Off
:Off
:On
:Outside P.
P P
P P
4-39