Kyocera KM-C830 Operation Manual page 68

Section 3 Troubleshooting
Message
Add toner.(CMYK)
"Document in memory. Add Toner."
"Time to replace the oil kit."
"Replace the oil kit now."
"Paper Misfeed."
"Misfeed in feeder.
Remove original(s)."
"Memory Full"
"Call for Service"
"Time for maintenance.(ABCD)"
3-4
There is insufficient toner left in the indicated toner container. Refer to the Operation
Guide for your copier and replace the indicated container as soon as possible (C =
cyan, M = magenta, Y = yellow, K = black).
Toner has run out during printing of received documents, so that no more documents
can be printed out. The rest of the documents will be entered into memory.
Refer to the Operation Guide for your copier and replace the indicated toner container
as soon as possible. Once you replace the toner container and printing is enabled, the
documents that were stored in memory will be printed out.
It is almost time to replace the oil kit. Refer to the Operation Guide for your copier and
replace the oil roller as soon as possible.
Replacement of the oil kit is required. Refer to the Operation Guide for your copier and
replace the oil roller.
Paper has jammed somewhere in the fax machine. Refer to the Operation Guide for
your copier and remove the jammed paper from the fax machine without leaving any
loose scraps.
A document has jammed in the DF. Refer to the included Operation Guide for your
copier or copier and remove the jammed document.
Then, reset all of the documents in the DF. The fax will recount the number of
documents that were already scanned and will start the scanning operation once again
from the document that jammed.
The memory has reached its capacity while scanning in documents. Press the Enter
key and then select "Yes" if you want to transmit those documents that have already
been completely scanned. If you want to completely cancel the transmission, use the
cursor up or the cursor down key to select "No" and then press the Enter key.
* If you do not press the Enter key within a certain amount of time, the Auto Clear
function will engage and all corresponding data will be erased from memory.
* In order to transmit all of the documents after you have completely canceled the
operation, try transmission procedure again after memory becomes available or after
you create available space in memory.
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service center or the place of purchase.
If "C" and a 3-digit number are displayed as well, inform the service personnel of the
displayed number.
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service center or the place of purchase. The required
maintenance kit (A – D) will be indicated in the message display.
Procedure Page
___
___
___
___
___
___
1-24
4-13
4-45
___
___