Kyocera KM-C830 Operation Manual page 156

Section 8 Reference Information Section 8 Reference Information
CODE
A communication error occurred during transmission at high transmission speed. The destination party's fax may not have
the corresponding high speed reception capabilities. If the destination party's fax number was dialled using an abbreviated
U01721
number or one-touch key, change the transmission speed registered for that number to a lower setting and perform
transmission procedures again.
U01800 - A communication error occurred during reception at high transmission speed. Perform reception procedures again after
U01820 having the transmitting party lower the transmission speed.
A communication error occurred during reception at high transmission speed. Your unit may not have the corresponding
U01821 high speed reception capabilities. Perform reception procedures again after having the transmitting party lower the
transmission speed.
An F-Code Based Relay Broadcast Transmission command was received, but transmission to the remaining final
destination(s) was impossible because the destination fax phone number(s) that was(were) registered for the
U02200
corresponding F-Code Relay Box in your fax machine has(have) been deleted. Check the information registered in your fax
and have the initial transmitting station perform the transmission operation again.
An F-Code Based Relay Broadcast Transmission command was received, but was unsuccessful because the F-Code
U02400 Relay Box ID that the initial transmitting station entered did not match the one registered in your fax. Check the information
registered in your fax and have the initial transmitting station perform the transmission operation again.
Polling Reception was attempted, but was unsuccessful because no documents had been placed in advance in the
U03000
transmitting party's fax. Check with the transmitting party.
The transmitting party's fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to
U03200 receive documents from that party's F-Code Box, but was unsuccessful because there were no documents stored in the
corresponding F-Code Box.
An error has occured due to one of the following reasons. Check with the other party.
1 A Polling Reception was attempted in order to receive documents from the other party's fax, but was unsuccessful
because Password Check Communication was turned ON in the other party's fax and the necessary password did not
U03300 match.
2 The transmitting party's fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order
to receive documents from that party's F-Code Box, but was unsuccessful because Password Check Communication
was turned ON in the other party's fax and the necessary password did not match.
Polling Reception was attempted, but was unsuccessful because the password input in the transmitting party's fax and the
U03400
self-station ID of the receiving party did not match. Check with the other party.
The transmitting party's fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to
U03500 receive documents from that party's F-Code Box, but was unsuccessful because the F-Code Box number that you entered
was not registered in the other party's fax.
8-8
CAUSE AND/OR PROCEDURE FOR CORRECTION