Kyocera KM-C830 Operation Manual page 71

Problem
During registration of an Encryption
Box, an error occurs when I enter
the box number and I cannot
register the Encryption Box.
I am not able to print out
documents from my Encryption
Box.
I am not able to perform Encrypted
Communication.
I am not able to perform Remote
Switching.
Check point
Is the box number you are trying to
enter the same as the subaddress
already registered for an F-Code Based
Relay Box (or F-Code Based
Confidential Box)?
Are the Encryption Box number and ID
that you entered correct?
Did the transmitting party perform the
appropriate registration procedure for
the abbreviated number or one-touch
key (designated for Encrypted
Transmission) as decided in advance
with the receiving party?
Did the receiving party perform the
appropriate registration procedure for
the appropriate Encryption Box as
decided in advance with the transmitting
party?
Is the Encryption Key you used correct?
Is your telephone service set for pulse
dialing?
Did you use the correct Remote
Switching number?
Section 3 Troubleshooting
Procedure
You CANNOT register an Encryption
Box number that is identical to a
registered F-Code Box subaddress.
Select a different Encryption Box
number.
Check the registered Encryption Box
information.
Check the information to be registered
once again with the other party.
Check the information to be registered
once again with the other party.
Check the Encryption Key to be
registered once again with the other
party.
Some telephones allow you to transmit
the desired tone signals. Refer to the
Instruction Manual for the telephone
being used.
Check the registered number.
(Factory default setting: 55)
Page
___
___
1-32
1-36
4-42
4-40
___
4-5
3-7