Modifying And Deleting; Using A Chain Dial Key - Kyocera KM-C830 Operation Manual

Section 2 Various Functions of this Fax

(2) Modifying and Deleting

* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
1. Perform steps 1 - 3 of "(1) Registering", page 2-7.
Chain:
Press 1-Touch Key
2. Press the one-touch key (chain dial key) containing the chain dial
information you want to modify or delete.
3. Perform the following procedure that corresponds to what you
want to do:
> Modifying registered information
Use the cursor up or the cursor down key to select the information
you want to modify. Then press the Enter key.
* Follow the steps related to the desired information in
"(1) Registering", page 2-7, to change that information.
Chain:05
End
v :0777
DDL-Chicago
> Deleting the chain dial key
1 Press the Stop/Clear key.
* If you want to cancel the deletion procedure, simply press the
Stop/Clear key again.
Chain:05
Delete
2 Press the Enter key.
Chain:05
Deleted
4. If you are finished modifying and/or deleting chain dial keys,
press the Reset key. The operation panel will return to the initial
mode settings.
2-8
JUL-08-2001 12:00
Press ENTER key

(3) Using a Chain Dial Key

* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
1. If the operation involves the transmission of documents, set the
documents you want to transmit.
Enter Destination
2. Press the desired one-touch key that was registered as a chain
dial key.
v :DDL-Chicago
Enter Destination
3. Enter the other party's fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys or the directory.
v :02468
Press START key.
* Once the other party's fax number is entered, the displayed
chain dial number or name will be replaced in the message
display by the other party's fax number or name.
* If you want to enter the fax number once again from the
beginning, simply press the Stop/Clear key.
4. Press the Start key.
The communication operation will begin automatically.
JUL-08-2001 12:00
JUL-08-2001 12:00
1
Document:8 / x11
2
1 /
Document:8 x11
2
1
/
Document:8 x11
2