Table of Contents
Advertisement
OEM – Installation guide
TM
MorphoWave
Section 3 : Installation Procedure
To connect wire to block connector, insert cable in the round hole of the connector.
To remove wire, insert a flat screw driver (0.4x2.0max) in the rectangular hole of the
connector and pull the corresponding wire.
Power Supply
POE and external power supply are not used at the same time: if both power supplies
are used, priority is given to external power supply. If external power supply is shut
down, switch to POE without reboot is not guarantee.
2015_2000009096 V4
May 2017
Figure 13: Cabling layout
This document and the information therein are the property of Morpho.
They must not be copied or communicated to a third party without the prior written authorization of Morpho
37
Advertisement
Table of Contents
