Table of Contents
Advertisement
OEM – Installation guide
TM
MorphoWave
Section 1 : Introduction
Drop voltage = loss of power due to wire resistance and its length: V2 = V1 – Drop
voltage
Caution with battery usage
Battery must be an UL certified reference.
Caution with Power over Ethernet (POE) usage
After use, the temperature of the POE module (optional) may be high:
after power cut off, wait 5mn before working on connectors area.
Europe information
Morpho hereby declares that products delivered (MorphoAcces Sigma, MorphoWave
Desktop) with the MorphoWave
with following listed standards:
EMC Directive 2004/108/CE.
R&TTE Directive (1999/5/CE).
ROHS Directive 2011/65.
USA information
Devices comply with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) these devices may not cause harmful
interference, and (2) these devices must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Responsible Party:
Morpho,
11, boulevard Gallieni
92130 Issy-les-Moulineaux – France
NOTA :
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
2015_2000009096 V4
May 2017
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
TM
OEM bundle have been tested and found compliant
This document and the information therein are the property of Morpho.
They must not be copied or communicated to a third party without the prior written authorization of Morpho
11
Advertisement
Table of Contents
