Recommendations For Terminal Implementation - Safran Morpho MorphoWave OEM Installation Manual

Recommendations for terminal implementation

Every installation is unique. Sometimes the issues are well defined and can be handled
in a standard fashion; sometimes the issues are very specific and may not be
immediately recognizable.
Morpho recommends following these steps for a successful installation:

Plan the installation - Choose the type of hardware required, decide if a network is
required, and decide on the location and number of required terminals.

Unpack all items - Unpack all items and check against the packing list.

Install network hardware components - Install the cabling and components needed
to run the system.

Install software - Install the software needed to set up the terminals.

Pre-configure device - Connect the terminals to the Ethernet, supply power to the
terminals, and pre-configure the terminals.

Mount devices - Mount the terminals in their final locations

Power distribution and device hook up - Connect the terminals wiring via the back
panel of the MorphoAccess Sigma.

Power-up procedure - Check the power connections, verify if battery is attached
and then start the system safely. First Boot Assistant screen is displayed, where you
can perform fundamental configuration.
This document and the information therein are the property of Morpho.
14
They must not be copied or communicated to a third party without the prior written authorization of Morpho
OEM – Installation guide
TM
MorphoWave
Section 1 :Introduction
2015_2000009096 V4
May 2017