Table of Contents
Advertisement
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this unit to ensure compliance with category B FCC
restrictions.
Canada information
WARNING TO USERS IN THE CANADA / ATTENTION POUR LES UTILISATEURS AU
CANADA
Devices comply with Industry Canada license-exempt RSS standard(s), and with ICES
003 standard for version(s) without RFID reader. Operation is subject to the following
two conditions: (1) these devices may not cause interference, and (2) these devices
must accept any interference, including interference that may cause undesired
operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
UL information
This product has been evaluated by UL regarding "UL 294 Access Control System Units
; Six Edition ; Dated May 10, 2013" and "UL 294B Power Over Ethernet (POE) Power
Sources for Access Control Equipment" First Edition Dated May 10, 2013" on the
following functionality
Biometric Access granted/ Access Denied
This document and the information therein are the property of Morpho.
12
They must not be copied or communicated to a third party without the prior written authorization of Morpho
OEM – Installation guide
TM
MorphoWave
Section 1 :Introduction
2015_2000009096 V4
May 2017
Advertisement
Table of Contents
