Table of Contents
Advertisement
Safety Instructions
The installation of this product should be made by a qualified service Person and should
comply with all local regulations.
For MorphoWave
12V-24V and 1A. min (at 12V) in conformity with Safety Electrical Low Voltage (SELV).
The power supply cable length should not exceed 10 meters. Others components of
the MorphoWave
This product is intended to be installed with a power supply complying with IEC60950-
1, in accordance with the NEC Class 2 requirements; or supplied by a listed IEC60950-1
external Power Unit marked Class 2, Limited Power source, or LPS and rated 12VDC, 1A
minimum or 24VDC, 0,5A minimum.
In case of building-to-building connection it is recommended to connect 0V to ground.
Ground cable must be connected with the terminal block Power Ground.
Note that all connections of the MorphoWave
of SELV (Safety Electrical Low Voltage) type.
For UL294 installation, length of communication (RS422-RS485/Wiegand) and I/Os
(GPI/GPO) cables must not exceed 30 meters.
Wiring Recommendations
Morpho recommends using a gauge AWG20 for 12V power supply when POE supply is
not used.
The voltage specified is the one measured on the product block connector: 12V-24V (-
15% / +10%)
For information, this table shows the maximum drop voltage observed on the terminal
MorphoWave
Gauge
AWG
20
22
24
10
This document and the information therein are the property of Morpho.
They must not be copied or communicated to a third party without the prior written authorization of Morpho
TM
OEM it is strongly recommended to use a class II power supply at
TM
OEM are provided with their own power supply.
TM
OEM:
Maximum
Diameter
(mm)
voltage
@ 1m (V)
0.81
0.64
0.51
V1
L
MorphoWave
TM
OEM terminal described hereafter are
Maximum
drop
drop
voltage
@ 5m (V)
0.03
0.17
0.05
0.26
0.08
0.42
V2
OEM – Installation guide
TM
Section 1 :Introduction
Maximum
drop
voltage
@ 10m
(V)
0.33
0.53
0.84
2015_2000009096 V4
May 2017
Advertisement
Table of Contents
