Table of Contents
Advertisement
Remote PC Wave connection for maintenance
To operate a maintenance operation (software upgrade, debug log retrieval) it may
asked by Morpho support to connect manually on the PC Wave of the MorphoWave
OEM.
There are two solutions to connect to the PC Wave of the MorphoWave
-
To connect VGA cable, keypad and mouse.
-
To establish a Windows remote session thanks to the internal network
available on reserved ports of the Ethernet switch. This solution will be
detailed below.
The procedure to apply:
-
Use a laptop running Windows 7 Pro operating system.
-
Let the MorphoWave
-
Plug an Ethernet wire on one of the reserved ports of the Ethernet switch.
Connect this cable to the laptop.
-
On the laptop a static IP address has to be set according steps below :
This document and the information therein are the property of Morpho.
88
They must not be copied or communicated to a third party without the prior written authorization of Morpho
MorphoWave
TM
OEM switched ON.
OEM – Installation guide
TM
Annex 1 : Maintenance
TM
TM
OEM:
2015_2000009096 V4
May 2017
Advertisement
Table of Contents
