Table of Contents
Advertisement
Step by step procedure
The recommended height for fixing of the terminal is 1.40m (camera height).
For an optimal use the terminal must be installed in an area where the
lighting conditions are controlled. Avoid direct exposure of the sensor to
the sun light and ensure good ambient lighting for face detection if used.
For face detection, the user has to face the product.
Power supply from electrical source shall be switched off before starting
the installation.
The strength of the attachment depends on the solidity of the wall on
which the terminal is mounted.
To ensure water tightness, the wall plate has to be sealed with a silicone
bead (refer to corresponding picture for process).
This document and the information therein are the property of Morpho.
32
They must not be copied or communicated to a third party without the prior written authorization of Morpho
Figure 7: Face camera viewing angle
OEM – Installation guide
TM
MorphoWave
Section 3 :Installation Procedure
2015_2000009096 V4
May 2017
Advertisement
Table of Contents
