Installation - Safran Morpho MorphoWave OEM Installation Manual

OEM – Installation guide
TM
MorphoWave
Section 3 : Installation Procedure

Installation

Required tools (not supplied)

Four (4) raw plugs + four (4) ø 3.5mm max and length 30mm screws.

One (1) screwdriver adapted to screws above.

One (1) Drill (with a drill bit diameter adapted to raw plugs above).

One (1) hole saw ø 67mm (depending on installation case).

One (1) Flat tip screwdriver (0.4x2.0) for block connector cable removal.

A (1) Torx T10 screwdriver

Deadbolt/door strike

Snubber diode required to protect regulated DC power supply from inductive
kickback (1N4007 diode or equivalent recommended)

Separate power supply for the deadbolt/door strike based on supplier's
recommendations.

External relay (if required)

Networking cable
For UL-294 compliance, an earthed screen in the wire or around all wires to/from
product is only required when the wires share space/compartment/tube with high
voltage cables.
Equipment from the initial package to use

One (1) Terminal's body.

One (1) wall plate.
2015_2000009096 V4
May 2017
This document and the information therein are the property of Morpho.
They must not be copied or communicated to a third party without the prior written authorization of Morpho
31