Table of Contents
Advertisement
6
Digital Output 2
Single Door Access Control (SDAC) implementation
A
1
1
6
6
If door contact is not used, GPI1 and GPO1 shall be connected together
Ethernet connection
Ethernet interface can be used to power the MorphoAccess Sigma Wave terminal
through POE (Power Over Ethernet - IEEE802.3af) mode. According to the POE standard
two modes are available: power on data pins and power on dedicated pins.
Use either one of these modes depending on POE implementation on your local
Ethernet network.
Ethernet cable shall be shielded
Default Ethernet configuration
By default, MorphoAccess Sigma Wave terminal is configured in Static mode.
IP address Mode
Static
This document and the information therein are the property of Morpho.
48
They must not be copied or communicated to a third party without the prior written authorization of Morpho
Push button /
Motion sensor
B
C
D
GPI0
1
1
GPI1
GPO0
GPO1
6
6
Figure 26: SDAC wiring
Parameter
Terminal IP address
Gateway IP address
Sub network mask
Host name
MorphoWave
Out
Reserved for Integrator Tamper Switch
External
Power supply
RLY1
Door
strike
RLY2
Factory value
192.168.1.10
192.168.1.254
255.255.254.0
MAsigma
OEM – Installation guide
TM
Section 3 :Installation Procedure
Door
contact
2015_2000009096 V4
May 2017
Advertisement
Table of Contents
