Table of Contents
Advertisement
MorphoAccess Sigma Wave installation
Before proceeding to the installation
Make sure that you have all the components described in "Components of the initial
package" section at your disposal.
Remove the wall plate. Keep this element at hand.
Remove the screw at the bottom of the product. Keep this element at hand.
It is then possible to fix the terminal on the wall.
The recommended height for fixing of the terminal is 1.40m (camera height).
For an optimal use the terminal must be installed in an area where the
lighting conditions are controlled. Avoid direct exposure of the sensor to
the sun light and ensure good ambient lighting for face detection if used.
This document and the information therein are the property of Morpho.
30
They must not be copied or communicated to a third party without the prior written authorization of Morpho
Figure 6: Removing wall frame and screw
OEM – Installation guide
TM
MorphoWave
Section 3 :Installation Procedure
1
2
2015_2000009096 V4
May 2017
Advertisement
Table of Contents
