Installation With The Mounting Spacer Supplied In The Package; Required Tools (Not Supplied); Equipment From The Initial Package To Use; Step By Step Procedure - Safran MorphoAccess J Series Installation Manual

®
MorphoAccess J Series – Installation Guide
3. Installation with the Mounting
Spacer supplied in the package

Required tools (not supplied)

Equipment from the initial package to use

Step by step procedure

DOCUMENT SSE-0000077503-04 - M
M D - R
ORPHO OCUMENT EPRODUCTION AND DISCLOSURE PROHIBITED
• One (1) Philips head screw driver
• One (1) Drill (with a Ø 5mm drill bit)
• Four (4) Ø 3mm screws
• One (1) Flat tip screw driver (diameter 2,5mm) for block connectors screws
• One (1) Terminal's body
• One (1) Smoked front cover
• One (1) Mounting Spacer
• Two (2) Block connectors
• Four (4) M3X25 screws
• Four (4) Rawplugs (for Ø 3mm screws)
• Two (2) M2.5X14 screws
• Two (2) Screw rubber caps
• One (1) L-shaped Torx screw driver
Power supply from electrical source shall be switched off before starting the
installation.
1. Confirm the presence of all the cables needed for the electrical installation
(see Section 4).
2. Drill in the wall 4 holes with a diameter of 5mm and fit them with the
rawplugs (see Figures 3.10 and 3.11).
2011
ARCH
Section 3: Installation procedure
25