b. Disconnect each power cord from the server.
8. Disconnect all peripheral cables from the server.
9. Remove the server from the rack .
10. Place the server on a flat, level work surface.
11. Remove the access panel .
12. Remove the riser cage.
13. To install the add-in card in the riser slot 1, do the following:
a. If installed, remove the full-height bracket from the add-in card.
Retain the bracket and screws for future use.
b. Install the low-profile bracket on the add-in card.
Installing the M.2 SATA SSD enablement option
139