Installing The Rack Rail Option - HPE ProLiant DL20 Gen10 Plus User Manual

Installing the rack rail option

Installing the rack rail option
The rack rails can be installed in round-hole, square-hole, or threaded-hole racks. The rack rails occupy 1U space in the rack.
The illustrations used in this procedure show an icon on the upper right corner of the image. This icon indicates the rack type for which
the action illustrated in the image is valid.
Round-hole rack
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Small slotted screwdriver—This tool is required only if you plan to install the server in a threaded-hole rack.
Procedure Procedure
1. Attach the sliding rails to the server:
a. Insert the spools on the sides of the server through the notches on the rails.
b. Slide the rail towards the rear panel to lock it into place.
2. Locate the orientation markers on the mounting rails.
The front end of the rails is marked as FRONT LEFT
The other end of the rails is marked as REAR
Square-hole rack Threaded-hole rack
FRONT LEFT or FRONT RIGHT
REAR.
FRONT RIGHT.
Installing the rack rail option 66