Mitsubishi Electric MELSERVO MR-J3-xT Instruction Manual page 83

3. CC-LINK COMMUNICATION FUNCTIONS
Code No.
8801h Deceleration time constant data RAM command of point
to table
88FFh Writes the deceleration time constants of point table No.
1 to 255 to RAM. These values are cleared when power
is switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the point table No.
8901h Dwell data RAM command of point table
to Writes the dwell data of point table No. 0 to 255 to RAM.
89FFh These values are cleared when power is switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the point table No.
8A01h Auxiliary function data RAM command of point table
to Writes the auxiliary function data of point table No. 0 to
8AFFh 31 to RAM. These values are cleared when power is
switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the point table No.
8B01h Position data EEP-ROM command of point table
to Writes the position data of point table No. 1 to 255 to
8BFFh EEP-ROM. Written to EEP-ROM, these values are held
if power is switched off.
8C01h The lower 16 bits are written in even code and the upper
to 16 bits in odd code.
8CFFh 8B01h to 8BFF: Position data in under 16 bits of point
8C01h to 8CFF: Position data in upper 16 bits of point
Example
Instruction code 8B13: Under 16 bits of point table No.
Instruction code 8C13: Upper 16 bits of point table No.
8D01h Servo motor speed data EEP-ROM command of point
to table
8DFFh Writes the servo motor speeds of point table No. 1 to
255 to EEP-ROM. Written to EEP-ROM, these values
are held if power is switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the point table No.
8E01h Acceleration time constant data EEP-ROM command of
to point table
8EFFh Writes the acceleration time constants of point table No.
1 to 255 to EEP-ROM. Written to EEP-ROM, these
values are held if power is switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the point table No.
8F01h Deceleration time constant data EEP-ROM command of
to point table
8FFFh Writes the deceleration time constants of point table No.
1 to 255 to EEP-ROM. Written to EEP-ROM, these
values are held if power is switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the point table No.
Item
table No. 1 to 255
table No. 1 to 255
19
19
Writing data (RWwn+3) contents
Convert the values into hexadecimal before making
setting.
Convert the values into hexadecimal before making
setting.
Convert the values into hexadecimal before making
setting.
Convert the values into hexadecimal before making
setting.
Convert the values into hexadecimal before making
setting.
Convert the values into hexadecimal before making
setting.
Convert the values into hexadecimal before making
setting.
3 - 29
(PLC Servo amplifier)