Security; Running Magic Files - Universal Robots E Series Original Instructions Manual

NOTE
• Although Remote Control limits your actions in PolyScope, you can still
monitor robot state.
• When a robot system is powered off in Remote Control, it starts up in Remote
Control.

29.4.6. Security

General
General allows you to configure Magic Files and to configure network access to the robot.
Magic files
A Magic File is a script on a USB drive that executes once it is inserted into the system.
Magic files have unrestricted privileges to make system changes, thus they must be considered as
a security liability.

Running magic files

1. In the Header, tap the Hamburger menu and select Settings.
2. Under Security, select General.
3. Enter your Admin password.
4. Enable Run Magic Files.
Configure Inbound Connections
Use Restrict inbound network access to a specific subnet to make sure network connections
originating from an IP-address outside the indicated subnet will be refused. For example:
• Use 192.168.1.0/24 to only allow access from hosts in the range of 192.168.1.0 –
192.168.1.255.
• Use 192.168.1.96 to allow inbound access only from one host.
Leave the field blank to disable subnet restriction.
Use Disable inbound access to additional interfaces (by port) to make sure any inbound
connection to the designated ports will be refused.
For example:
• Use 0-65535 to block all ports. Use 564 to block a specific port.
• Use 2318-3412,22,56-67 to block specific ports and specific ranges of ports.
UR5e 264
29. Hamburger menu
User Manual