Inspur ON5263M5 User Manual page 58

Table 6-16
Parameter
iSCSI Mode
Internet Protocol
Connection Retry
Count
Connection
Establishing Timeout
OUT-format ISID
Configure ISID
Enable DHCP
Initiator IP Address
Initiator Subnet Mask
Gateway
Target Name
Target Address
Target Port
Boot LUN
Authentication Type
Save Changes
Back to Previous Page
BIOS Settings
Advanced > Network Stack Configuration > iSCSI Configuration >
Add an Attempt
Description
Enabled for MPIO.
Options: Enabled/Disabled
This item is specific to IPv6.
Options: IP4/IP6/Autoconfigure
The minimum value is 0 and the maximum is
16. 0 means no retry.
The minimum value is 100 milliseconds and
maximum is 20 seconds.
OUT-format ISID in 6 bytes, default value is
derived from the MAC address. Only last 3
bytes are configurable.
Configure the out-format ISID
Enable/disable DHCP.
Options: Enabled/Disabled
Enter IP address in dotted-decimal notation.
Enter IP address in dotted-decimal notation.
Enter IP address in dotted-decimal notation.
The worldwide unique name of the target.
Only iqn. Format is accepted.
Enter Target address in IPV4, IPV6 or URL
format. You need to configure the DNS server
address in advance if it's a URL string.
Target Port
Hexadecimal representation of the LU
number.
Options: CHAP/Kerberos/None
System must be rebooted in order for
changes to take effect..
Back to Previous Page
Default Setting /
Format
Disabled
IP4
0
1000
Disabled
0.0.0.0
0.0.0.0
0.0.0.0
----
----
3260
0
None
----
----
49