Table of Contents
Advertisement
After BIOS firmware update is finished, BIOS NVRAM will be cleared, all BIOS
configuration will be reset to defaults. If BIOS and ME images are updated simultaneously,
it is recommended that to power off the server completely.
Step 1
On the WEB GUI, go to the Administration →BIOS Firmware Update, and then click Enter
Firmware Update Mode to enter the update mode.
BIOS Bin file Type has two selections: BIOS+ME or BIOS Only. Check the BIOS Setup
Options checkbox if you want to preserve BIOS setup options.
Step 2
Click Browse to select an image file, and then click Upload to upload and verify the file.
ME will enter the recovery mode, and then BMC will verify the image (verify size should
be 32M). Verify the image integrity to ensure that this is a BIOS image. If the verification
fails, BMC will stop the flash process and force ME to enter to the normal mode. If the
verification succeeds, click on the Proceed to update button to start the update. Wait for
about 3 minutes, then the flash process is complete, and ME will enter the normal mode.
140
BMC Settings
Advertisement
Table of Contents
