Inspur ON5263M5 User Manual page 36

7. Using the following instructions in Table 6-2 to create the RAID Volume.
Parameter
Name
RAID Level
Select Disks
Capacity
Create Volume
If a RAID Volume has not previously been created, it will be necessary to press <F10> to
Save & Exit and reboot after creating a RAID Volume in BIOS Setup.
BIOS Settings
Table 6-2 Creating a RAID Volume in UEFI Mode
Description
Enter a volume name less than 16 characters without
containing any special characters.
Select the RAID volume level.
Options:
•
•
•
•
Select which HDDs to make the RAID volume.
Set the volume capacity. When highlight this item, the
maximum capacity is shown in the Help area on the
right side.
After finishing the above settings, select this item to
create RAID volume.
RAID0 (Stripe): This RAID volume is allowed to be
made on 2 or more than 2 HDDs.
RAID1 (Mirror): This RAID volume is allowed to be
made on 2 HDDs.
RAID10 (RAID0+1): This RAID volume is allowed to
be made on 4 HDDs, which is only available when
HDD quantity is 4 or above.
RAID5 (Parity): This RAID volume is allowed to be
made on 3 or more than 3 HDDs.
27