Table of Contents
Advertisement
Power off the equipment, disconnect them with the power socket, wait for 10
1)
to 20 seconds, and then open the host cover.
Move the equipment to a well-ventilated place to dry the system at least for 24
2)
hours and make sure that the system is fully dried.
Close the host cover, reconnect the system to the power socket, and then
3)
power on.
In case of operation failure or other abnormal situations, please contact Inspur
4)
and get technical support.
3.
Pay attention to the position of system cables and power cables-avoid placing wires
in high foot traffic locations. Please do not place objects on the cables.
4.
Before removing the host cover, and/or touching the internal components, please
allow for the equipment to cool first. To avoid damaging the mainboard, please
power off the system and wait for five seconds, and then remove the components
from the mainboard and/or disconnect the peripheral device from the system.
Please remember that only service technicians trained by Inspur are authorized to
remove the cover of the host, and to remove and replace internal components.
5.
If there is modem, telecom or LAN options installed in the equipment, please pay
attention to the followings:
In the case of thunder and lightning, please do not connect or use the modem.
1)
Never connect or use the modem in a damp environment.
2)
Never insert the modem or telephone cables into the socket of network
3)
interface controller (NIC).
Before unpacking the product package, installing internal
4)
touching uninsulated cables or jacks of the modem, please disconnect the
modem cables.
6.
In order to prevent electrostatic discharge from damaging the electronic
components in the equipment, please pay attention to the followings:
Please remove any static electricity on your body before dismounting or
1)
touching any electronic component in the equipment, to prevent the static
electricity from conducting itself to the sensitive components. You may remove
the static electricity on the body by touching the metal earthing objects (such
as the unpainted metal surface on the rack).
Please do not take electrostatic sensitive components that are not ready to be
2)
installed for application out of the antistatic package materials.
While
working, please touch the earthing conductor or the unpainted metal
3)
surface on the cabinet regularly to remove any static electricity from the body
that may damage the internal components.
7.
Upon receiving the proper authorization from Inspur and dismounting the internal
components, please pay attention to the following:
Safety Instructions
components,
3
Advertisement
Table of Contents
