Option 2, Code Sf1/Su2 - HBM T10FS Mounting Instructions

Electrical connection
Fault:
Cause:
Remedy:
Fault:
Remedy:
50
Possible faults and their elimination
No signal at the output, amplifier indicates overflow.
Too little power, T10FS disconnects.
Switch position 3.
The calibration signal has been triggered by mistake.
Switch position 1.
6.4

Option 2, code SF1/SU2

On the stator housing, there are two 7‐pin device
connectors (Binder 723) and in the case of the speed
module option, there is also an 8‐pin device connector,
assigned in accordance with the selected option.
The supply voltage and the calibration signal of
connectors 1 and 3 are direct‐coupled via multifuses
(automatically resetting fuses).
A0785-150 HBM: public
T10FS