Table of Contents
Advertisement
Diagnostic / Diagnostic / Diagnose
A
A
LARM
Your machine is equipped with a set of controllers and sensors.
This means that operating alerts may appear on your terminal.
These alerts may be of different levels:
Red, with a «STOP»; it is vital that you stop the machine immediately and investigate the cause of the malfunction according to the
alert. In this case, the seeding quality is directly called into question.
Orange, with «WARNING»; it is a good idea to quickly investigate the cause of the problem in order to improve your machine's
operation. However, the seeding quality is not in doubt.
In certain cases, these alerts may lead to damage to your equipment. Example: calculator overheating.
Alarm level of gravity
Alarm descriptive text
Alarm code
Description of the alarms
A
LARM CODE
520456
Turbine speed too low during seeding
520457
520518
The seed drill must have actuators on all the rows
520521
The forward movement speed is to high, risk of blockage
520532
Low level alert when the doser is started up
520544 /
520656 /
520768
520545 /
520657 /
520769
520549 /
520661 /
520773
520554 /
520666 /
The flow rate test hatch is open
520778
520563 /
520675 /
520787
521088 ->
Blockage sensor disconnected or at fault
521151
521152 ->
Flap actuator disconnected or electronic board at fault
521215
521216 ->
521279
521472 /
Seed drill/Fertiliser distributor widths incompatible
521473
521474 /
The fertiliser distributor track does not correspond
521475
Tramline parameters incompatible with the actuator
521481
521482 ->
System electronic malfunction
522251
522257 ->
Too much dust on the blocking sensor No. X
522384
522385 ->
Hatch opening cylinder failure
522392
D
ESCRIPTION
Turbine speed too high
Doser speed too high
Doser speed too low
The doser speed is not stable
The gearbox casing is open
Row No. X blocked
to the seed drill setting
position
S
OLUTION
Increase the turbine speed
Reduce the turbine speed
Change the seeding configuration or contact your reseller
to top up your seed drill's equipment.
Reduce its working speed
Fill the 1 hopper
Perform another flow rate test,
increasing the groove volume slightly
Perform another flow rate test,
reducing the groove volume slightly
Contact your dealer.
Close the hatch
Close the casing
Contact your dealer.
Stop seeding and check the flow on the row concerned
Change the seeding configuration
or contact your reseller to top up your seed drill's equipment.
Contact your dealer.
Clean the blocking sensor No. X
Contact your dealer.
9
EN
201
Advertisement
Table of Contents
