SKY Agriculture Easydrill W 8020 Original Instructions Manual page 187

Equipements / Accessories / Ausrüstungen
E S
EED CONTROLLER
The seed controller's main ECU, which is placed under the distribution head, is equipped with two status LEDs.
Red LED
LED status
Quick flashing
OFF
always on
Green LED
LED status
Slow flashing
OFF
always on
Red LED
LED status
OFF
always on
Quick flashing
Slow flashing
Green LED
LED status
Slow flashing
Quick flashing Normal operation, with product passage detection.
OFF (with red LED
OFF)
OFF (with red LED
ON)
always on
The operation of the seed controller is only guaranteed with wheat.
Information
No communication with the flow sensors.
Normal operation
No CAN communication.
Information
Normal operation
No power supply voltage
Software updating
Information
Normal operation
Sensor dirty or obstructed.
No communication with the ECU
Sensor in configuration or acquisition mode.
Information
Normal operation, without product passage.
No power supply voltage
Sensor dirty.
Software updating
Check
Check the connections.
Check the connections.
Check
Check that the machine is under voltage.
Check that the update was successful.
Check
Check if the sensor is obstructed or dirty and clean it.
Check the connections.
Check
Check the connections.
Clean the blocking sensor No. X
7
EN
187