2) Accept the end user license agreement (EULA) by tapping the Accept button. If the end user license agree
ment (EULA) is not accepted, the Cockpit app cannot be used.
→ The welcome screen appears.
3) Tap the Add component button.
→ The "Preparation" screen appears. The serial number of the component should be entered here.
4) Follow the subsequent instructions on the screen.
5) After the PIN code is entered, a connection to the prosthesis is established.
→ While the connection is being established, 3 beep signals sound and the
The
symbol is displayed when the connection has been established.
→ Once the connection has been established successfully, the data are read from the prosthesis. This process
may take up to a minute.
The main menu will then appear with the name of the connected prosthesis.
INFORMATION
After the initial connection to the prosthesis has been established successfully, the app will connect automatically
each time it is started. No further steps are required.
9.3 Control elements for cockpit app
1
Product
2
1. Basic Mode
2. Golf
4
5
6
100%
1. Basic Mode
Genium 3B1/3B1=ST
1.
Call up the navigation menu (see Page 74)
2. Product
The component name can only be changed with the adjustment soft
change
ware.
3
3. If connections to more than one component have been saved, you can
switch between the saved components by tapping the entry change.
4. MyModes configured with the adjustment software.
Switching the mode by tapping the corresponding symbol and confirm
ing by tapping "OK".
5. Currently selected mode
6. Charge level of the component.
Component battery fully charged
Component battery empty
7
The current charge level is also displayed in %.
8
7. Display and name of the currently selected mode (e.g. 1. Basic Mode)
9
8.
Mute mode is activated
9.
Connection to component has been established
Connection to component has been interrupted. The app is attempt
ing to re-establish the connection automatically.
Cockpit app
symbol appears.
Ottobock | 73