Starting The Cockpit App For The First Time; Control Elements For Cockpit App - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

8.2.1 Starting the cockpit app for the first time

1) Tap the symbol of the Cockpit app (
→ The end user license agreement (EULA) is displayed.
2) Accept the end user license agreement (EULA) by tapping the Accept button. If the end user license agree­
ment (EULA) is not accepted, the Cockpit app cannot be used.
→ The welcome screen appears.
3) Hold the prosthesis with the sole of the foot facing up, or connect and then disconnect the battery charger, in
order to activate recognition (visibility) of the Bluetooth connection for 2 minutes.
4) Tap the Add component button.
→ The Connection Wizard opens and guides you through the process of establishing a connection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This process may take up to
a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
After the initial connection to the component has been established successfully, the app will connect automatically
each time it is started. No further steps are required.
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot facing up, or con­
necting and then disconnecting the battery charger), the component can be recognised by another device
(e.g. smartphone) within 2 minutes. If registration or establishing the connection takes too long, the process of
establishing a connection is cancelled. In this case, hold the component with the sole of the foot facing up again,
or connect and then disconnect the battery charger.

8.3 Control elements for cockpit app

1
Product
2
1. Basic Mode 2. Golf
4
5
6
100% 1. Basic Mode
C-Leg 3C98-3/3C88-3
).
1. Access the navigation menu (see page 34)
2. Product
The component name can only be changed with the adjustment soft­
change
ware.
3
3. If connections to more than one component have been saved, you can
switch between the saved components by tapping the change option
(see page 34).
4. MyModes configured with the adjustment software.
Switch the mode by tapping the corresponding icon, and confirm by
tapping "OK".
If deep sleep mode was enabled in the Cockpit app, this is displayed
here as well. For further information, see the section "Deep sleep
mode" (see page 42).
7
5. Currently selected mode
8
6. Charge level of the component.
Component battery fully charged
Component battery empty
Component battery charging
The current charge level is also displayed in %.
7. Display of and designation for the currently selected mode (e.g. 1.
Basic Mode)
8. Connection to component has been established
Connection to component has been interrupted. The app is attempt­
ing to re-establish the connection automatically.
No existing connection to the component.
Cockpit app
symbol appears.
33