Control Elements For Cockpit App - Otto Bock X2 Series Instructions For Use Manual

→ The Connection Wizard opens and guides you through the process of establishing a con­
nection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
appears.
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This pro­
cess may take up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
After the initial connection to the component has been established successfully, the app will
connect automatically each time it is started. No further steps are required.
Only when "DUAL" marking is present (see Page 60)
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot
facing up, or connecting and then disconnecting the battery charger), the component can be
recognised by another device (e.g. smartphone) within 2 minutes. If registration or establishing
the connection takes too long, the process of establishing a connection is cancelled. In this
case, hold the component with the sole of the foot facing up again, or connect and then discon­
nect the battery charger.

8.3 Control elements for cockpit app

1
Product
2
1. Basic Mode 2. Golf
4
5
6
100% 1. Basic Mode
1. Access the navigation menu (see Page 78)
2. Product
The component name can only be changed with the adjust­
change
3
ment software.
3. If connections to more than one component have been
saved, you can switch between the saved components by
tapping the entry change.
4. MyModes configured with the adjustment software.
Switching the mode by tapping the corresponding symbol
and confirming by tapping "OK".
5. Currently selected mode
7
6. Charge level of the component.
8
9
The current charge level is also displayed in %.
7. Display and name of the currently selected mode (e.g. 1.
Basic Mode)
8. Mute mode is activated
9.
is attempting to re-establish the connection automatically.
No existing connection to the component.
Component battery fully charged
Component battery empty
Component battery is being charged
Connection to component has been established
Connection to component has been interrupted. The app
symbol
77