Technical Data - Otto Bock C1000 SF Instructions For Use Manual

The design, manufacturing and requirements for the intended use of the product are based on the expected ser­
vice life. These also include the requirements for maintenance, ensuring effectiveness and the safety of the
product.
Using the product beyond the specified expected service life leads to increased residual risk and should only take
place subject to the due diligence and deliberations of qualified personnel.
If the service life is reached, the user or a responsible attendant should contact the qualified personnel who fitted
the product or the manufacturer's servicing department (see inside rear cover or back page for address). Here the
user can obtain information about known risks and the current options for refurbishing the product.

10 Technical data

INFORMATION
► Much of the technical data below is given in mm. Please note that product settings – unless otherwise spe­
cified – cannot be adjusted in the mm range but only in increments of approx. 0.5 cm or 1 cm.
► Note that the values achieved during adjustment may deviate from the values specified below. The deviation
can be ±10 mm and ±2°.
General information
Application class (in compliance with DIN
EN 12184)
Dimensions and weights
Seat width
Seat depth
Seat height
Lower leg length
Angle of the seat surface
Angle of leg to seat
Distance from arm support to seat
Front position of the arm supports
Arm support height
Arm support length
Back support height
Back support angle adjustment
Seat inclination
Seat tilt
Overall width
Overall height
Overall length
Weight when empty*
Max. load (user weight)*
Turning circle**
Turning radius
Drive wheel tyre size
Caster wheel tyre size
Ground clearance
Tyre type
Air pressure (only with pneumatic tyres)
* The specified weights vary according to the selected options and model.
C1000 SF
Class B
430/480 mm
370–530 mm
530–630 mm (incl. seat cushion)
390–520 mm
0°–6°
90°–170°
225–325 mm
300–580 mm
160–260 mm
370 mm
550–650 mm
Power: adjustable by up to 45° (depending on the seat depth)
Maximum back angle for seat depth: 370 mm = 27°; 380 mm = 31°;
390 mm = 35°; 400 mm = 40°; from 410 mm = 45°
0°/3°/6°
Power: adjustable by up to 15°
650 mm
1600
1200
200 kg
Standard version: 136 kg (for 6 km/h); 100 kg (for 10 km/h)
1400 mm
925 mm
Front: 14"
Rear: 10"
100 mm
PU tyres, pneumatic (depending on equipment)
Adjust the tyre pressure according to the specifications on the tyre
sidewall to prevent injuries or damage to the product:
• 14" drive wheel: 3.5 bar/350 kPa/50 PSI
• 10" caster wheel: 3.5 bar/350 kPa/50 PSI
Technical data
63