Controlling Power Seat Functions - Otto Bock C1000 SF Instructions For Use Manual

Use
INFORMATION
► Please also observe the generally applicable safety instructions in the section "Power seat functions" >
"Safety instructions" (see Page 35).
► Observe the instructions for use in the sections "Controlling power seat functions" (see Page 40) and "Joy­
stick functions" (see Page 41).
INFORMATION
Note that, before switching from an already executed special function (S2, S3) to another special function (S2,
S3), the seat should first be brought into the sitting position. Only then should the new special function be oper­
ated and executed.
The power wheelchair can be equipped with power prone functions.
26
27

6.12.8 Controlling power seat functions

INFORMATION
If your power wheelchair is equipped with an LCD monitor, please also read the section "Separate LCD monitor"
(see Page 42).
• Power seat functions are activated and controlled via the control panel (see Page 21).
• Holding the [Mode] button (approx. 2 seconds; ) activates control of the first power seat function.
• The LCD screen indicates the currently selected seat function (see the following section "Joystick functions").
The driving function is not available at this time and the speed level indicator switches off.
• To switch between the various seat functions, press the [Mode] button briefly or move the joystick to the right.
• Once a seat function has been activated, it is adjusted by moving the joystick forward or backward.
• The electric motor moves the seat according to the seat function as long as the joystick is deflected and stops
at the end positions.
• Holding the [Mode] button again (approx. 2 seconds) deactivates the seat function in the selected position. The
driving function is available again and the speed level indicator on the LCD screen is lit.
40
Tilted prone function (see fig. 26): The seat and leg
support are brought into a 45° tilted prone position
(relaxed position) via the "S2" power function. The
adjustment is continuous.
Prone function (half prone; see fig. 27): The seat
and leg support are brought into a half prone position
via the "S3" power function. The adjustment is continu­
ous.
C1000 SF