Battery Charging Information; Battery Charger; Charging The Battery - Otto Bock C1000 SF Instructions For Use Manual

Use

6.10.3 Battery charging information

The range of the power wheelchair is determined by the battery capacity. The battery capacity is influenced by
many factors. In addition to the temperature, battery age and driving conditions, the charging cycle also has a pro­
nounced effect on the capacity and therefore on the range.
Batteries reach their full capacity only after approx. 20 charge cycles. Only if the full capacity of the batteries has
been reached can the power wheelchair achieve the stated range.
At temperatures of < 0 °C/32 °F the battery capacity drops by up to 35% in relation to the capacity for an outside
temperature of 20 °C/68 °F. This shortens the range of the power wheelchair accordingly. Moreover the charge
level displayed on the control panel can differ more significantly from the actual battery capacity.
The following information should be observed for an optimal charging cycle:
• The batteries can be charged at any time, regardless of the remaining charge level.
• It takes about 10 to 12 hours until a discharged battery (only 1 flashing segment) is fully charged. When the
charging process is complete, the battery charger can remain connected to the power wheelchair with no risk
of overcharging or damaging the battery. The battery charger features a programmed recharging phase that
will maintain the battery capacity at the level that has been reached.
• If the power wheelchair is used every day, the battery should be charged every night.
• Never discharge the batteries completely (deep discharge).
• The batteries will gradually discharge if the wheelchair is not used for extended periods of time. If the power
wheelchair is not used for an extended period, the batteries should be charged 1 x per week to maintain their
capacity.
• After charging the batteries, the circuit breaker should be deactivated if the wheelchair is not used for more
than 3 days.
• The power wheelchair control device must be switched off while the batteries are charging to allow all of the
charging current to be fed into the battery.

6.10.4 Battery charger

NOTICE
Improper use of the battery charger
Damage to the battery charger, damage to the battery due to user error
► Only use battery chargers from Ottobock, which have been verified and approved by the manufacturer for use
with the respective batteries (observe information on the battery charger).
► Ensure that the information on the battery charger nameplate matches the country-specific voltage of the
respective mains grid.
► Only use the battery charger within the specified temperature and humidity limits.
► Place the battery charger on a level surface.
► If you locate the battery charger near a window, protect it from direct sunlight.
► Avoid overheating of the battery charger. Do not cover the ventilation slits in the case.
► Switch the control unit off during the charging process so that all of the charging current is fed into the bat­
tery.
► Avoid dust, dirt and moisture.
► Only clean the battery charger with a dry cloth.
The battery charger is designed for maintenance-free and low-maintenance batteries.
Please see the instructions for use supplied with the battery charger for further details on use and on the LED dis­
plays.

6.10.5 Charging the battery

WARNING
Improper use of the battery charger
Risk of electric shock due to contact with live components
► Do not touch live electrical components. The battery charger and its cables are live when the charger is on.
► Do not remove any insulation or protective covers.
32 C1000 SF