Mains Switch; Power Supply At In 2560 Xtw And In 2560 Pw - Lauda IN 130 T Operation Manual

3.5

Mains switch

3.6

Power supply at IN 2560 XTW and IN 2560 PW

Installation of the mains cable on site
V6
The devices have a mains switch on the right side of the device. This is
designed either as a toggle switch or as a rotary switch. Position [0] switches
the device off, position [I] switches it on.
Notes for electric installation on site:
The mains cable must be installed by a qualified electrician.
n
The mains cable must be installed on site by the user. The installation is
n
implemented with hard wiring or with an approved plug with an adequate
rating.
For three-phase devices the rating of the circuit breaker must match
n
the power consumption loading of the device. The value will be found
on the type plate. In each case, select the next higher value. Using an
excessively high rated circuit breaker is not permissible.
Integral Process Thermostats and High-Temperature Thermostats
Mains switch on the single-phase device
The toggle switch is also designed as a safety switch. If the current is
too high, the toggle switch trips and disconnects the device from the
mains supply. The device can be used again by switching the toggle
switch to position [I]. If the safety switch trips again, contact the
LAUDA Service department.
Mains switch on the three-phase device
The automatic fuse may only be switched on by a qualified electri-
cian!
The rotary switch is not designed as a safety switch. The three-
phase device has a separate automatic fuse built in. If the automatic
fuse trips, contact the LAUDA Service department.
NOTICE!
Use of a mains cable with impermissible dimensions
Device damage
The specifications on the type plate of the device are deci-

sive for the cross-section of the mains cable.
Comply with the national regulations of the respective
country when installing the mains cable.
25 / 198